Stepcraft 2 Assembly Manual Step 1.3  -  SC2-03


 
 

Stepcraft 2 Assembly Manual Step 1.3 (SC2-03)

Step 1.3 of the Stepcraft-2 series machines Tips on assembling the end switch bracket


Avoiding Cutting Screws on Assembly Step 1.4

 
 

Stepcraft 2 Assembly Manual Step 1.4 

Many people feel they need to cut the M6x10 screws to get them to tighten down properly into the lead screw holder. This happens because you think that the screw is tight, but the design tolerance of the brass lead screw holder (part #59) is such that you can apply more pressure to properly tighten the screw without the need to shorten the length of the screw. 


Routing The Wires On The X-Z Connector Step  1.6

 
 

Stepcraft 2 Assembly Manual Step 1.6

The manual illustrates in Step 1.6, how to route the wires, but the watching this video can help make this step much easier. 

Track Roller Holder Assembly Step 1.8


 
 

Stepcraft 2 Assembly Manual Step 1.8

While the manual explains this step very well, we thought Stepcraft-2 owners could benefit from a short video that further explains the best way to complete this step.