CNC FAQ


Answering all of your CNC Questions

For both STEPCRAFT and Non-STEPCRAFT CNC Systems

The M31 Macro for the Tool Length Sensor is automatically installed when you use the STEPCRAFT Multi-Installer. The best way to make sure you are up to date with our latest profiles and macros is to download the STEPCRAFT Multi-Installer here. This installer will automatically install the most up to date profiles and macros.

If you find that after using the tool length sensor your end mill is slightly above or slightly digs into your material, you may need to preform a small adjustment to the M31 macro. To preform this adjustment, you can find the procedure here.

Software Troubleshooting Tool Length Sensor Automatic Tool Changer 4/17/20, 2:53 PM 2,074 Views Direct Link

If you find that your tool length sensor (TLS) is functioning properly, but not touching the very top of your material, you may need to preform a quick calibration. This ensures that the tool length sensor is accurate and reliable. The following video will walk you through the simple TLS calibration...

 
 
 

Maintenance Tool Length Sensor Automatic Tool Changer Stepcraft Attachments and Access 4/17/20, 2:53 PM 2,533 Views Direct Link